Hi,
2012/10/28 Anders Hedlund anders.j.hedlund@gmail.com:
This adds support for WIFI/BT GPIOs which were previously missing.
Signed-off-by: Anders Hedlund anders.j.hedlund@gmail.com Cc: Enric Balletbo i Serra eballetbo@iseebcn.com Cc: Jonas Zetterberg jozz@jozz.se
board/isee/igep0020/igep0020.h | 6 ++++++ 1 file changed, 6 insertions(+)
diff --git a/board/isee/igep0020/igep0020.h b/board/isee/igep0020/igep0020.h index 3335ecc..283b75e 100644 --- a/board/isee/igep0020/igep0020.h +++ b/board/isee/igep0020/igep0020.h @@ -132,6 +132,12 @@ static void setup_net_chip(void); MUX_VAL(CP(MMC1_DAT1), (IEN | PTU | EN | M0)) /* MMC1_DAT1 */\ MUX_VAL(CP(MMC1_DAT2), (IEN | PTU | EN | M0)) /* MMC1_DAT2 */\ MUX_VAL(CP(MMC1_DAT3), (IEN | PTU | EN | M0)) /* MMC1_DAT3 */\
MUX_VAL(CP(CAM_HS), (IDIS | PTU | DIS | M4)) /* GPIO_94 */\MUX_VAL(CP(CAM_VS), (IDIS | PTU | DIS | M4)) /* GPIO_95 */\MUX_VAL(CP(MMC2_DAT4), (IDIS | PTU | DIS | M4)) /* GPIO_136 */\MUX_VAL(CP(MMC2_DAT5), (IDIS | PTU | DIS | M4)) /* GPIO_137 */\MUX_VAL(CP(MMC2_DAT6), (IDIS | PTU | DIS | M4)) /* GPIO_138 */\MUX_VAL(CP(MMC2_DAT7), (IDIS | PTU | DIS | M4)) /* GPIO_139 */\ MUX_VAL(CP(UART3_TX_IRTX), (IDIS | PTD | DIS | M0)) /* UART3_TX */\ MUX_VAL(CP(UART3_RX_IRRX), (IEN | PTD | DIS | M0)) /* UART3_RX */\ MUX_VAL(CP(I2C1_SCL), (IEN | PTU | EN | M0)) /* I2C1_SCL */\-- 1.7.10.4
Thanks for the patch but u-boot should only mux the pins they use, as u-boot does not use wifi this is not applicable here.
Did you have problems with wifi ? Then we should check if these pins are muxe'd at kernel level, I think so.
Cheers, Enric