Hi,
On 10/31/2014 03:25 AM, Simon Glass wrote:
This series adds driver model support for serial and GPIO for sunxi. Since I only have a sun7i board to test with, I have added a new config for the pcDuino3, which uses device tree and driver model. This should make it fairly easy to enable for the other boards at some point.
This series is available at u-boot-dm/sunix-working.
Changes in v3:
- Move enabling of 'dm' command to sunxi-common.h
- Put enabling of DM GPIO into sunxi-common.h
- Rebase to master
- Move DM enable options to sunxi-common
Changes in v2:
- Remove references to exynos and tegra
- Use the word 'bank' instead of 'port'
- Split non-sunxi patches into a separate dependent series
Simon Glass (6): dm: sunxi: dts: Add sun7i device tree files dm: sunxi: Add a new config for an FDT-based pcDuino3 dm: sunxi: Add pinmux functions which take a bank parameter dm: sunxi: Make sure that GPIOs are requested dm: sunxi: Modify the GPIO driver to support driver model dm: sunxi: Add support for serial using driver model
Thanks, merged and pushed to u-boot-sunxi/next, I'm going to run some tests now, and when those are done I'll also push this to u-boot-sunxi/master and send a pull-req.
Regards,
Hans