This series updates the Designware I2C driver to support reading its timing from the device tree and handling it in units of nanoseconds instead of clock cycles.
A new function converts from nanoseconds to the units used by the I2C controller and makes sure that the requested bus speed is not exceeded. This is more accurate than the existing method.
The series includes a few smaller clean-ups in the same driver.
There is currently an existing configuration method used just for a few x86 boards (Baytrail). This method is retained but it should be removed in favour of using the device tree. I have not done this in this series since I am not sure of the timings to use.
Simon Glass (12): i2c: designware_i2c: Add more registers i2c: designware_i2c: Don't allow changing IC_CLK i2c: designware_i2c: Include clk.h in the header file i2c: designware_i2c: Rename 'max' speed to 'high' speed i2c: designware_i2c: Use an enum for selected speed mode i2c: designware_i2c: Use an accurate bus clock instead of MHz i2c: designware_i2c: Bring in the binding file i2c: designware_i2c: Read device-tree properties i2c: designware_i2c: Drop scl_sda_cfg parameter i2c: designware_i2c: Put hold config in a struct i2c: designware_i2c: Rewrite timing calculation i2c: designware_i2c: Add spike supression
.../i2c/i2c-designware.txt | 73 +++++ drivers/i2c/designware_i2c.c | 263 ++++++++++++++---- drivers/i2c/designware_i2c.h | 53 +++- drivers/i2c/designware_i2c_pci.c | 4 +- 4 files changed, 332 insertions(+), 61 deletions(-) create mode 100644 doc/device-tree-bindings/i2c/i2c-designware.txt