On Mon, 24 Jan 2022 at 18:15, Andre Przywara andre.przywara@arm.com wrote:
So far all Allwinner based boards were doing some not-so-lowlevel-setup in lowlevel's s_init() routine. This includes the initial clock, timer and pinmux setup, among other things. This is clearly out of the "absolute bare minimum to get started" scope that lowlevel_init.S suggests for this function.
Since we have an SPL, which is called right after s_init(), move those calls to our board_init_f() function. As we overwrite this only for the SPL, this has the added benefit of not doing this setup *again* shortly afterwards, when running U-Boot proper.
This makes gpio_init() to be called from the SPL only, so pull this code into a CONFIG_SPL_BUILD protected part to avoid build warnings.
Signed-off-by: Andre Przywara andre.przywara@arm.com
arch/arm/mach-sunxi/board.c | 27 ++++++++++++++------------- 1 file changed, 14 insertions(+), 13 deletions(-)
Reviewed-by: Simon Glass sjg@chromium.org Tested on: orangepi_pc2, orangepi_pc, A20-OLinuXino_MICRO Tested-by: Simon Glass sjg@chromium.org
diff --git a/arch/arm/mach-sunxi/board.c b/arch/arm/mach-sunxi/board.c index 3ef179742c5..390c9f8850d 100644 --- a/arch/arm/mach-sunxi/board.c +++ b/arch/arm/mach-sunxi/board.c @@ -75,6 +75,7 @@ ulong board_get_usable_ram_top(ulong total_size) } #endif
+#ifdef CONFIG_SPL_BUILD static int gpio_init(void) { __maybe_unused uint val; @@ -172,7 +173,6 @@ static int gpio_init(void) return 0; }
-#if defined(CONFIG_SPL_BOARD_LOAD_IMAGE) && defined(CONFIG_SPL_BUILD) static int spl_board_load_image(struct spl_image_info *spl_image, struct spl_boot_device *bootdev) { @@ -227,18 +227,6 @@ void s_init(void) "mcr p15, 0, r0, c1, c0, 1\n" ::: "r0"); #endif -#if defined CONFIG_MACH_SUN6I || defined CONFIG_MACH_SUN8I_H3
/* Enable non-secure access to some peripherals */tzpc_init();-#endif
clock_init();timer_init();gpio_init();-#if !CONFIG_IS_ENABLED(DM_I2C)
i2c_init_board();-#endif
eth_init_board();}
#define SUNXI_INVALID_BOOT_SOURCE -1 @@ -335,6 +323,19 @@ u32 spl_boot_device(void)
void board_init_f(ulong dummy) { +#if defined CONFIG_MACH_SUN6I || defined CONFIG_MACH_SUN8I_H3
/* Enable non-secure access to some peripherals */tzpc_init();+#endif
clock_init();timer_init();gpio_init();+#if !CONFIG_IS_ENABLED(DM_I2C)
i2c_init_board();+#endif
eth_init_board();spl_init(); preloader_console_init();-- 2.17.6