Re: [U-Boot] Building u-boot for iMX28 and getting error in mkimage of missing command line parameter CONFIG_IMX_CONFIG

Thanks. That did it!

However, now my new U-boot built from the mainstream Uboot runs and also loads and unpacks the Linux kernel - but it dies after that. However, my original U-boot from tlib works fine. Are there some patches and/or settings I am missing?

Thanks,

Bills

On 7/26/2012 3:24 PM, Fabio Estevam wrote:

Bill,

On Thu, Jul 26, 2012 at 3:28 PM, Billbsousan@techsi.com wrote:

...

All,

 I am working on building the latest u-boot for the imx28evk board.  I

have done the following steps:

1. git clone git://git.denx.de/u-boot-imx.git
2. setup paths for finding my cross-compiler
3. make mx28evk_config
4. make u-boot.imx

'make u-boot.imx' is not correct for mx28.

You should do:

make u-boot.sb

Please follow the instructions at doc/README.mx28_common for the correct process.

Regards,

Fabio Estevam