Hi,
On 3/8/22 08:18, Jan Havran wrote:
dwmci_setup_cfg was clearing all modes except the mode equivalent to required bus width. Moreover, for buswidth = 1 was set the 4-bit mode.
This sets host caps to all modes from 1-bit up to the required mode.
Signed-off-by: Jan Havran havran.jan@email.cz
drivers/mmc/dw_mmc.c | 10 ++++++---- 1 file changed, 6 insertions(+), 4 deletions(-)
diff --git a/drivers/mmc/dw_mmc.c b/drivers/mmc/dw_mmc.c index 4232c5eb8c..9c139140e4 100644 --- a/drivers/mmc/dw_mmc.c +++ b/drivers/mmc/dw_mmc.c @@ -602,11 +602,13 @@ void dwmci_setup_cfg(struct mmc_config *cfg, struct dwmci_host *host, cfg->host_caps = host->caps;
if (host->buswidth == 8) {
cfg->host_caps |= MMC_MODE_8BIT;cfg->host_caps &= ~MMC_MODE_4BIT;
I don't remember exactly. But when i had added this line, there was some issue. I will check again. Thanks!
Best Regards, Jaehoon Chung
- } else {
cfg->host_caps |= MMC_MODE_4BIT;
cfg->host_caps |= MMC_MODE_8BIT | MMC_MODE_4BIT | MMC_MODE_1BIT> + } else if (host->buswidth == 4) {cfg->host_caps |= MMC_MODE_4BIT | MMC_MODE_1BIT;- } else {
cfg->host_caps &= ~MMC_MODE_8BIT & ~MMC_MODE_4BIT;cfg->host_caps |= MMC_MODE_1BIT;