Enable i.MX thermal DM driver to mx6sabre_common.h file. Since the thermal is used in init_sequence_f, so define the CONFIG_SYS_MALLOC_F_LEN to support DM driver using in pre relocation phase.
Additional, thermal driver depends on ocotp, make sure to enable CONFIG_MXC_OCOTP when CONFIG_IMX6_THERMAL is selected.
Signed-off-by: Ye.Li B37916@freescale.com Signed-off-by: Nitin Garg nitin.garg@freescale.com --- include/configs/mx6sabre_common.h | 7 ++++++- 1 files changed, 6 insertions(+), 1 deletions(-)
diff --git a/include/configs/mx6sabre_common.h b/include/configs/mx6sabre_common.h index 1e10422..9fdd841 100644 --- a/include/configs/mx6sabre_common.h +++ b/include/configs/mx6sabre_common.h @@ -25,6 +25,11 @@ #define CONFIG_INITRD_TAG #define CONFIG_REVISION_TAG
+#define CONFIG_DM +#define CONFIG_DM_THERMAL +#define CONFIG_SYS_MALLOC_F_LEN (1 << 10) +#define CONFIG_IMX6_THERMAL + #define CONFIG_SYS_GENERIC_BOARD
/* Size of malloc() pool */ @@ -37,7 +42,7 @@ #define CONFIG_MXC_UART
#define CONFIG_CMD_FUSE -#ifdef CONFIG_CMD_FUSE +#if defined(CONFIG_CMD_FUSE) || defined(CONFIG_IMX6_THERMAL) #define CONFIG_MXC_OCOTP #endif