-----Original Message----- From: Michael Walle [mailto:michael@walle.cc] Sent: Monday, May 02, 2011 3:35 AM To: u-boot@lists.denx.de Cc: Michael Walle; Prafulla Wadaskar Subject: [PATCH] mvsata: issue hard reset on initialization
Before the actual initialization do a hard reset of the SATA port and the connected device.
Copying Albert for his ack
Regards.. Prafulla . .
Signed-off-by: Michael Walle michael@walle.cc Cc: Prafulla Wadaskar prafulla@marvell.com
drivers/block/mvsata_ide.c | 10 +++++++++- 1 files changed, 9 insertions(+), 1 deletions(-)
diff --git a/drivers/block/mvsata_ide.c b/drivers/block/mvsata_ide.c index 3d6993a..ff880d5 100644 --- a/drivers/block/mvsata_ide.c +++ b/drivers/block/mvsata_ide.c @@ -33,7 +33,9 @@
/* SATA port registers */ struct mvsata_port_registers {
- u32 reserved1[192];
- u32 reserved0[10];
- u32 edma_cmd;
- u32 reserved1[181]; /* offset 0x300 : ATA Interface registers */ u32 sstatus; u32 serror;
@@ -76,6 +78,7 @@ struct mvsata_port_registers {
- and for SStatus DETection.
*/
+#define MVSATA_EDMA_CMD_ATA_RST 0x00000004 #define MVSATA_SCONTROL_DET_MASK 0x0000000F #define MVSATA_SCONTROL_DET_NONE 0x00000000 #define MVSATA_SCONTROL_DET_INIT 0x00000001 @@ -115,6 +118,11 @@ static int mvsata_ide_initialize_port(struct mvsata_port_registers *port) u32 status; u32 timeleft = 10000; /* wait at most 10 ms for SATA reset to complete */
- /* Hard reset */
- writel(MVSATA_EDMA_CMD_ATA_RST, &port->edma_cmd);
- udelay(25);
- writel(0, &port->edma_cmd);
- /* Set control IPM to 3 (no low power) and DET to 1 (initialize) */ control = readl(&port->scontrol); control = (control & ~MVSATA_SCONTROL_MASK) | MVSATA_PORT_INIT;
-- 1.7.2.3