[U-Boot] [PATCH 5/8] arm: zynq: Enable DM_ETH and DM_MMC only if subsystem is enabled

Do not enable DM_ETH/MMC if subsystems are not enabled. This saves memory for memory constrained boards like cse.

Signed-off-by: Michal Simek michal.simek@xilinx.com ---

arch/arm/Kconfig | 4 ++-- 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/arch/arm/Kconfig b/arch/arm/Kconfig index fdeef4d05d9d..d5fb5fed5c70 100644 --- a/arch/arm/Kconfig +++ b/arch/arm/Kconfig @@ -746,10 +746,10 @@ config ARCH_ZYNQ select SPL_BOARD_INIT if SPL select SPL_OF_CONTROL if SPL select DM - select DM_ETH + select DM_ETH if NET select DM_GPIO select SPL_DM if SPL - select DM_MMC + select DM_MMC if MMC select DM_SPI select DM_SERIAL select DM_SPI_FLASH