Dear Chuck,
in message IIEEICKJLNEPBBDJICNGGEMCKLAA.chuckmeade@mindspring.com you wrote:
Sorry, forgot to include the instructions in that msg. It has been a while since I flashed mine, so I am pretty sure these are correct. Let me know if they are not, and I can retry them here.
First, the standard ARM BDI2000 cable does not get used with this board. Use the 20-pin ARM/XScale BDI2000 cable for the osk5912.
Using the config file I sent, at the bdi2000 prompt type: unlock 0 2000 2 erase 0 prog 0 u-boot_omap5912_osk.bin binary
Thanks for all the hints, which work fine.
In my case the BDI2000 config file needed more trickier tuning. I have noi idea why, but I had to remove the "WAKEUP" from the default config file and use the following commands instead (only available with latest firmware, as I understand):
SCANINIT r1:t1:w1000:t0:w1000: ;assert reset and toggle TRST SCANINIT r0:w30000 ;release reset and wait
Thanks goes once more to Ruedi Dummermuth from Abatron; without his help I'd still be searching.
Best regards,
Wolfgang Denk