On 12/02/2011 05:19 PM, Robert P. J. Day wrote:
and, at this point, i would think that all i need to do is:
=> bootm 400000 ## Booting image at 00400000 ... Image Name: Linux-2.6.37 Created: 2011-12-02 23:08:06 UTC Image Type: PowerPC Linux Kernel Image (gzip compressed) Data Size: 1301506 Bytes = 1.2 MB Load Address: 00000000 Entry Point: 00000000 Verifying Checksum ... OK Uncompressing Kernel Image ... OK
You need to use a cuImage, just as you did with lite5200.
Or update U-Boot and pass a device tree.
and that's where it hangs.
i have no idea if it's still booting properly but i've simply screwed up the serial port setting.
does this set of steps look reasonable? the configuration, the building, the TFTP, the verification steps, the "bootm" command? this is what's printed when the board resets:
U-Boot 0.4.0 (Apr 13 2004 - 15:01:22)
CPU: XPC860xxZPnnD4 at 80 MHz: 16 kB I-Cache 8 kB D-Cache FEC present Board: TQM860LDB0A3-P80.208 DRAM: 16 MB FLASH: 8 MB In: serial Out: serial Err: serial Net: SCC ETHERNET [PRIME], FEC ETHERNET PCMCIA: No Card found
am i just missing something obvious? what should i use for the kernel console setting? i'm open to suggestions.
console=ttyCPM0
-Scott