Hi Stefano,
On 26/09/2011 13:35, Stefano Babic wrote:
Hi Albert,
please pull u-boot-imx/next (already rebased on u-boot-arm/next after you merged u-boot-ti) into your u-boot-arm/next.
Best regards, Stefano
The following changes since commit f3340eeaf574b3297e801a563089c90d23e84f8d:
arm, davinci, da8xx: add cpuinfo (2011-09-23 15:50:39 -0400)
are available in the git repository at: git://www.denx.de/git/u-boot-imx.git next
Fabio Estevam (25): ARM: mx25: Print the silicon revison ARM: mx25: Print the source of reset MX31: mx31pdk: Remove nand_spl config.mk file MX31: Improve readability for reset cause mx31pdk: Change the prompt as per other i.MX boards MX25: tx25: Avoid the usage of extern in C file MX25: Add initial support for MX25PDK MX31: Disable watchdog during low-power modes mx31pdk: Remove dram_init_banksize() mx25pdk: Remove dram_init_banksize() mx31ads: Remove dram_init_banksize() imx31_litekit: Remove dram_init_banksize() mx31pdk: Place machine ID into board config mx25pdk: Place machine ID into board config mx31ads: Place machine ID into board config imx31_litekit: Place machine ID into board config mx51evk: Place machine ID into board config mx53loco: Place machine ID into board config mx53smd: Place machine ID into board config mx53ard: Place machine ID into board config mx53evk: Place machine ID into board config zmx25: Remove dram_init_banksize() zmx25: Place machine ID into board config zmx25: Fix build warning due to 'get_reset_cause' defined but not used vision2: Place machine ID into board config
Jason Liu (1): cosmetic: fsl_pmic: cosmetic for the help message
Marek Vasut (19): EfikaMX: Adjust undocumented magic constant in config file FEC: Use proper accessor to read register in debug call FEC: Use defined constant instead of magic number FEC: Kill mode select FIXME's FEC: Add RMII mode support FEC: Allow selection of MII mode via CONFIG_FEC_XCV_TYPE FEC: Abstract access to fec->eth in MII operations FEC: Allow multiple FECes FEC: Allow registering MII postconfiguration callback FEC: Add timeout for chip reset FEC: Squish "got MAC from fuse" message, make it debug() FEC: Move imx_get_mac_from_fuse() definition to fec_mxc.h MX5: Modify the PLL decoding algorithm MX5: Add AHB clock reporting and fix IPG clock reporting MX5: Clean up the output of "clocks" command I2C: mxc_i2c rework ATA: Squash warnings in mxc_ata. EfikaMX: Add imximage config for Efika SB EfikaSB: Add preliminary EfikaSB support
Applied to u-boot-arm/next, thanks!
Amicalement,