On Tue, May 13, 2014 at 08:44:01PM -0500, Rob Herring wrote:
On Mon, May 5, 2014 at 10:26 AM, Tom Rini trini@ti.com wrote:
- Drop DEBUG
- Drop defines we can use the default of.
- Drop CONFIG_GICV3 and related defines, we aren't using interrupts and do not need to configure the interrupt controller.
- Provide a larger malloc pool.
- Correct default locations for kernel / initrd / device tree
Signed-off-by: Tom Rini trini@ti.com
[...]
-#define CONFIG_GICV3
/*#define CONFIG_ARMV8_SWITCH_TO_EL1*/
/*#define CONFIG_SYS_GENERIC_BOARD*/ @@ -94,20 +90,11 @@ /* Generic Timer Definitions */ #define COUNTER_FREQUENCY (0x1800000) /* 24MHz */
-/* Generic Interrupt Controller Definitions */ -#ifdef CONFIG_GICV3 -#define GICD_BASE (0x2f000000) -#define GICR_BASE (0x2f100000) -#else -#define GICD_BASE (0x2C001000) -#define GICC_BASE (0x2C002000) -#endif
IIRC, these should be needed if secure to non-secure switching is done.
Not something I can test so OK, I'll put that back next go-round.
#define CONFIG_SYS_MEMTEST_START V2M_BASE #define CONFIG_SYS_MEMTEST_END (V2M_BASE + 0x80000000)
/* Size of malloc() pool */ -#define CONFIG_SYS_MALLOC_LEN (CONFIG_ENV_SIZE + 128 * 1024) +#define CONFIG_SYS_MALLOC_LEN (CONFIG_ENV_SIZE + (8 << 20))
This seems like another candidate for some sane default value.
Well, the previous value was relatively sane. It only needs bumping up beyond env + a bit of room if you: - Have UBI/UBIFS - Expect to use a decompressor.
The latter isn't that common, but if we start doing Image.gz more often might be. But it'll also be worth some quick benchmarking to see if it's any sort of time win or not.
/* SMSC91C111 Ethernet Configuration */ #define CONFIG_SMC91111 1 @@ -121,7 +108,6 @@ #define CONFIG_CONS_INDEX 0
#define CONFIG_BAUDRATE 115200 -#define CONFIG_SYS_BAUDRATE_TABLE { 9600, 19200, 38400, 57600, 115200 } #define CONFIG_SYS_SERIAL0 V2M_UART0 #define CONFIG_SYS_SERIAL1 V2M_UART1
@@ -166,10 +152,9 @@
/* Initial environment variables */ #define CONFIG_EXTRA_ENV_SETTINGS \
"kernel_addr=0x200000\0" \"initrd_addr=0xa00000\0" \"initrd_size=0x2000000\0" \"fdt_addr=0x100000\0" \
"kernel_addr=0x80080000\0" \"initrd_addr=0x90000000\0" \"fdt_addr=0x88000000\0" \Don't we want the _r variants here?
Good point, need to sanitize that wrt doc/README.pxe and such.