On 19-03-10 13:02:28, Marek Vasut wrote:
On 3/10/19 12:42 PM, Abel Vesa wrote:
If CONFIG_SPL_OS_BOOT and FIT_IMAGE_TINY are enabled, the os will not be set to anything and therefore will remain as IH_OS_INVALID. What's needed here is to have IH_OS_U_BOOT as default. And since using the mkimage oneline command (that is, no its file), the loadables can't be specified, so we allow firmware as a fallback.
Wouldn't it make more sense to fix the mkimage ?
OK then, I'll add a new option to mkimage for loadables.
Signed-off-by: Abel Vesa abel.vesa@nxp.com Tested-by: Fabio Estevam festevam@gmail.com
Changes since v1:
- added braces to get rid of the build warning
common/spl/spl_fit.c | 10 +++++++--- 1 file changed, 7 insertions(+), 3 deletions(-)
diff --git a/common/spl/spl_fit.c b/common/spl/spl_fit.c index db43626..bfcf71a 100644 --- a/common/spl/spl_fit.c +++ b/common/spl/spl_fit.c @@ -478,11 +478,15 @@ int spl_load_simple_fit(struct spl_image_info *spl_image,
/* Now check if there are more images for us to load */ for (; ; index++) {
uint8_t os_type = IH_OS_INVALID;
uint8_t os_type = IH_OS_U_BOOT;Does that mean invalid image type is then always handled as if it was U-Boot ? That looks kinda iffy.
Hmm, fair enough. I'll do the fix in mkimage and this change won't be necessary then.
node = spl_fit_get_image_node(fit, images, "loadables", index);
if (node < 0)break;
if (node < 0) {node = spl_fit_get_image_node(fit, images,"firmware", index);if (node < 0)break;}ret = spl_load_fit_image(info, sector, fit, base_offset, node, &image_info);
-- Best regards, Marek Vasut