[U-Boot-Users] AT91SAM9260 + DP83848 phy

Dear list, I am currently working on a custom board, trying to get the National DP83848 Phy to work properly with the AT91SAM9260 in u-boot 1.2.0; Everything goes fine (reset is ok, can read phy id) until I read the link status bit. The link status bit is never set, so I never get a good connection.

I have tried the following:

-Bit banged the MDIO directly to the via the parallel port as per National's suggestion. The link status bit went high in this case, so I do not believe there are any wiring faults in our board.

Does anybody know of a u-boot driver for the phy with the AT91SAM9260? Has anyone had any success with this combination?

Thanks,

Dave