Re: ZynqMP boot: no messages from SPL other than "Debug uart enabled"

Hi Michal,

export DEVICE_TREE=... should cause that CONFIG_DEFAULT_DEVICE_TREE will remain assigned to zcu100 but SPL/u-boot proper will be using zcu102.

You can check it by looking at build folder ls spl/board/xilinx/zynqmp/ where you see which psu_init was used (recommend to make mrproper before you check this to remove old builds)

OK, that seems to be the case.

You should look at this. configurations { default = "config_17";

             config_17 {
                     description = "zynqmp-zcu102-rev1.1";
                     firmware = "atf";
                     loadables = "uboot";
                     fdt = "fdt_17";
             };

That's what SHOULD be there, but it isn't. "default" points to "config_1", not 17. Why? And how do I change this (sorry for my ignorance, but editing the file and rebuilding u-boot doesn't work because the file gets overwritten)?

Cheers,

András