Several customers are using UART2 (normally the serial console for U-Boot) as connections to printers or other peripherals that are not tolerant of stray inputs during reset.
Provide a simple way to eliminate output on the serial port by conditionally configuring these pads as GPIOs during U-Boot.
Signed-off-by: Eric Nelson eric.nelson@boundarydevices.com --- board/boundary/nitrogen6x/nitrogen6x.c | 6 ++++++ 1 file changed, 6 insertions(+)
diff --git a/board/boundary/nitrogen6x/nitrogen6x.c b/board/boundary/nitrogen6x/nitrogen6x.c index e795492..621cdbc 100644 --- a/board/boundary/nitrogen6x/nitrogen6x.c +++ b/board/boundary/nitrogen6x/nitrogen6x.c @@ -77,9 +77,15 @@ static iomux_v3_cfg_t const uart1_pads[] = { MX6_PAD_SD3_DAT7__UART1_TX_DATA | MUX_PAD_CTRL(UART_PAD_CTRL), };
+/* #define CONFIG_SILENT_UART */ static iomux_v3_cfg_t const uart2_pads[] = { +#ifndef CONFIG_SILENT_UART MX6_PAD_EIM_D26__UART2_TX_DATA | MUX_PAD_CTRL(UART_PAD_CTRL), MX6_PAD_EIM_D27__UART2_RX_DATA | MUX_PAD_CTRL(UART_PAD_CTRL), +#else + MX6_PAD_EIM_D26__GPIO3_IO26 | MUX_PAD_CTRL(UART_PAD_CTRL), + MX6_PAD_EIM_D27__GPIO3_IO27 | MUX_PAD_CTRL(UART_PAD_CTRL), +#endif };
#define PC MUX_PAD_CTRL(I2C_PAD_CTRL)