Some platforms (such as the Lichee Pi 4A) have their dwmac device addressable only in high memory space. Storing the node's base address on 32 bits is not possible in such case.
Use platform's physical address type to store the base address.
Signed-off-by: Nils Le Roux gilbsgilbert@gmail.com ---
drivers/net/designware.c | 8 ++++---- 1 file changed, 4 insertions(+), 4 deletions(-)
diff --git a/drivers/net/designware.c b/drivers/net/designware.c index a174344b3e..327732fbf7 100644 --- a/drivers/net/designware.c +++ b/drivers/net/designware.c @@ -678,8 +678,8 @@ int designware_eth_probe(struct udevice *dev) { struct eth_pdata *pdata = dev_get_plat(dev); struct dw_eth_dev *priv = dev_get_priv(dev); - u32 iobase = pdata->iobase; - ulong ioaddr; + phys_addr_t iobase = pdata->iobase; + phys_addr_t ioaddr; int ret, err; struct reset_ctl_bulk reset_bulk; #ifdef CONFIG_CLK @@ -740,7 +740,7 @@ int designware_eth_probe(struct udevice *dev) * or via a PCI bridge, fill in plat before we probe the hardware. */ if (IS_ENABLED(CONFIG_PCI) && device_is_on_pci_bus(dev)) { - dm_pci_read_config32(dev, PCI_BASE_ADDRESS_0, &iobase); + dm_pci_read_config32(dev, PCI_BASE_ADDRESS_0, (u32 *)&iobase); iobase &= PCI_BASE_ADDRESS_MEM_MASK; iobase = dm_pci_mem_to_phys(dev, iobase);
@@ -748,7 +748,7 @@ int designware_eth_probe(struct udevice *dev) pdata->phy_interface = PHY_INTERFACE_MODE_RMII; }
- debug("%s, iobase=%x, priv=%p\n", __func__, iobase, priv); + debug("%s, iobase=%llx, priv=%p\n", __func__, (u64)iobase, priv); ioaddr = iobase; priv->mac_regs_p = (struct eth_mac_regs *)ioaddr; priv->dma_regs_p = (struct eth_dma_regs *)(ioaddr + DW_DMA_BASE_OFFSET);