The boot mode detection assumes that BOOT_DEVICE_MMC2 should always result in MMCSD_MODE_FS, but MMCSD_MODE_RAW is also a valid option for this port.
The current logic also avoids looking at the bootmode pin strapping, which should be the primary means of determining whether a device is being booted in MMCSD_MODE_EMMCBOOT mode.
Switch around the logic to check the boot mode to determine whether the eMMC boot mode is expected or MMC/SD boot mode. From there we can look at the boot mode config if in MMC/SD boot mode to determine whether to attempt RAW or FS based booting.
This change allows U-Boot to also be successfully booted from RAW offsets in addition to from a filesystem.
Signed-off-by: Martyn Welch martyn.welch@collabora.com --- arch/arm/mach-k3/am625_init.c | 19 +++++++++---------- 1 file changed, 9 insertions(+), 10 deletions(-)
diff --git a/arch/arm/mach-k3/am625_init.c b/arch/arm/mach-k3/am625_init.c index da2229d0bf..a91c15ca4e 100644 --- a/arch/arm/mach-k3/am625_init.c +++ b/arch/arm/mach-k3/am625_init.c @@ -173,21 +173,20 @@ void board_init_f(ulong dummy) u32 spl_mmc_boot_mode(struct mmc *mmc, const u32 boot_device) { u32 devstat = readl(CTRLMMR_MAIN_DEVSTAT); + u32 bootmode = (devstat & MAIN_DEVSTAT_PRIMARY_BOOTMODE_MASK) >> + MAIN_DEVSTAT_PRIMARY_BOOTMODE_SHIFT; u32 bootmode_cfg = (devstat & MAIN_DEVSTAT_PRIMARY_BOOTMODE_CFG_MASK) >> MAIN_DEVSTAT_PRIMARY_BOOTMODE_CFG_SHIFT;
- switch (boot_device) { - case BOOT_DEVICE_MMC1: - if ((bootmode_cfg & MAIN_DEVSTAT_PRIMARY_MMC_FS_RAW_MASK) >> - MAIN_DEVSTAT_PRIMARY_MMC_FS_RAW_SHIFT) - return MMCSD_MODE_EMMCBOOT; - return MMCSD_MODE_FS; - - case BOOT_DEVICE_MMC2: - return MMCSD_MODE_FS;
+ switch (bootmode) { + case BOOT_DEVICE_EMMC: + return MMCSD_MODE_EMMCBOOT; + case BOOT_DEVICE_MMC: + if (bootmode_cfg & MAIN_DEVSTAT_PRIMARY_MMC_FS_RAW_MASK) + return MMCSD_MODE_RAW; default: - return MMCSD_MODE_RAW; + return MMCSD_MODE_FS; } }