Hi Simon,
On Tue, Mar 31, 2020 at 7:57 AM Simon Glass sjg@chromium.org wrote:
Hi Bin,
On Mon, 30 Mar 2020 at 03:42, Bin Meng bmeng.cn@gmail.com wrote:
Hi Simon,
On Sun, Mar 29, 2020 at 4:58 AM Simon Glass sjg@chromium.org wrote:
Hi Bin,
On Thu, 26 Mar 2020 at 10:38, Bin Meng bmeng.cn@gmail.com wrote:
Hi Simon,
On Fri, Mar 27, 2020 at 12:20 AM Simon Glass sjg@chromium.org wrote:
HI Bin,
On Wed, 25 Mar 2020 at 01:25, Bin Meng bmeng.cn@gmail.com wrote:
Hi Simon,
On Tue, Mar 24, 2020 at 9:45 PM Simon Glass sjg@chromium.org wrote: > > At present we query the memory map on boards which don't support it. Fix > this by only doing it on Apollo Lake. >
I wonder isn't this check already covered in mrccache_get_region() below:
ret = dm_spi_get_mmap(dev, &map_base, &map_size, &offset); if (!ret) { entry->base = map_base; } else { ret = dev_read_u32_array(dev, "memory-map", reg, 2); if (ret) return log_msg_ret("Cannot find memory map\n", ret); entry->base = reg[0]; }
Yes it is, so long as dm_spi_get_mmap() returns an error, as it does with my patch.
So does ich_get_mmap_bus() returns 0 on chromebook_link?
Well on link the SPI peripheral is not a PCI device but a child of the PCH. It is possible to read the registers but at present this only works once you have the mmio_base (i.e. the PCH device is probed). This function needs to work before probing (since FSP-S access needs to happen without probing PCI).
I suspect it would be possible to read the PCH base without probing it, but it does add quite a bit of special-case code. What do you think?
I've looked at this. So this function mrccache_get_region() is broken on Minnowmax too. The call to uclass_find_first_device() returns nothing because SPI flash is not probed hence no SF device is found.
OK, so add to the DT, or do something else?
There is already "memor-map" propert (see below) y in Chromebook DTS so I am not sure what else needs to be added to the DT, as you mentioned?
spi: spi { #address-cells = <1>; #size-cells = <0>; compatible = "intel,ich9-spi"; u-boot,dm-pre-reloc; spi-flash@0 { #size-cells = <1>; #address-cells = <1>; u-boot,dm-pre-reloc; reg = <0>; compatible = "winbond,w25q64", "jedec,spi-nor"; memory-map = <0xff800000 0x00800000>; rw-mrc-cache { label = "rw-mrc-cache"; reg = <0x003e0000 0x00010000>; u-boot,dm-pre-reloc; }; }; };
So isn't the failure on Link caused by uclass_find_first_device()? I think replacing uclass_find_first_device() with uclass_first_device() will fix failures for at least Minnowmax? The comment says:
/* * Find the flash chip within the SPI controller node. Avoid probing * the device here since it may put it into a strange state where the * memory map cannot be read. */
What issue did you see if we probe the SPI controller and flash?
Regards, Bin