19 Aug
2004
19 Aug
'04
4:16 p.m.
In message 1092921384.24546.9.camel@pavement.sandburst.com you wrote:
After having read the README and some code, I was wondering if there is a way to switch, at runtime (rather than at compile time) from UART0 to UART1.
The board is the ocotea, ppc440gx, u-boot 1.1.2, build tools from ELDK3
Not out of the box. But doc/README.serial_multi shows what we did on MPC8xx processors; this can be used as a starting point to extend it for 4xx as well.
Best regards,
Wolfgang Denk
--
Software Engineering: Embedded and Realtime Systems, Embedded Linux
Phone: (+49)-8142-4596-87 Fax: (+49)-8142-4596-88 Email: wd@denx.de
That said, there may be good reasons for what you did beyond obsequi-
ous sycophantic parody. Perhaps you might be so kind as to elucidate.
-- Tom Christiansen in 5ldjbm$jtk$1@csnews.cs.colorado.edu