Re: [U-Boot-Users] Booting with attached BDI but not alone (only ICTRL remained in BDI cfg)

just a stupid idea: did you connect a pull-up resistor to BKPT on your board?

My Board is an evaluation board and it worked till few months ago.

Now I removed any initialization from cgf file of BDI. Only special register 158 is set to 0x00000007 and I cannot remove this, otherwise BDI complains about halting the target.

Anyway the board continues to boot only using BDI not alone.

Now I don't understand what could be the problem. Should I set SPR 158 from within u-boot to 0x00000007?

Bye, Antonio.