Re: [U-Boot-Users] AT91 and u-boot tests

In message 001f01c5c82a$4e86b5c0$0600a8c0@kmobile you wrote:

u-boot always configured and compiled "as is" for at91rm9200dk

You are aware that you cannot use the same configuration for your tests?

u-boot-1.1.3

• running in ram : DOES NOT BOOT
• stored in flash with boot.bin as pre-loader and then u-boot as bootloader : DOES NOT BOOT
• stored in flash as unique bootloader : OK BUT FAILS KERNEL UNCOMPRESSION

P.S. Looking into boot.bin sources seems that it required for Master clock, PLL frequency and SDRAM very low level settings.

Your message is not helpful as it is totally unclear if you change the configuration (i. e. with or without CONFIG_SKIP_LOWLEVEL_INIT and/or CONFIG_SKIP_RELOCATE_UBOOT #defined in your cofiguration which is *essential*. Please make sure to read the documentation (README).

Best regards,

Wolfgang Denk