
Yes.. U r right. Iam not using the ixdp425 (development) board. What iam using is a customised board having IXP425.
On this board, I tried with the REDBOOT prebuilt utility for ixdp425 board ( development board) from the web and I could see the console message on my hyperterminal.
I was wondering y I cannot observe the same with my U-boot. is there any extra configuration needed?
I checked the CFG_IXP425_CONSOLE macro in u-boot and saw thats its assigned to IXP425_UART1 of the IXP425 chip. I also checked the circuit diagram of my customised target platform and found that the console is connected to UART1 only.
What could be causing this problem?
Stefan Roese wrote:
Hi Queenie,
On Monday 11 June 2007, Queenie wrote:
Iam a newbie in this field. I have a customed target board having IXP425. This board has been working fine with Redboot. I do not have the working source code for Redboot but only the bin file which works fine. I now want to customise the u-boot and make u-boot the bootloader for this board.
I have downloaded u-boot-1.1.6. Also I have downloaded the npe microcode from intel website (IPL_ixp400NpeLibrary-2_4). The tool chain I have downloaded is arm-linux-tools-20061213.tar.gz I have added the toolchain in my $PATH (.bash_profile file) I complied my u-boot for IXDP425 by giving the command "make ixdp425_config" and the "make all"
Yes, but if I understand you correctly, then you don't have the Intel IXDP425 board, but a custom specific board. Correct? I assume that there are some differences to the Intel board. What are those differences? You have to *port* U-Boot to your specific hardware.
It complied sucessfully and gave me a u-boot.bin and u-boot.srec file.
I used this u-boot.bin file and loaded it into my target board flash using an ICE. after this is accomplished, I restarted the board and connected the console of my target board so that i could observe the bootloader prompt on the hyperterminal. I see nothin on the console (hyperterminal) I have connect it with baud rate 115200, 8 data bits, parity bits none, 1 stop bit and flow control as none. I even tried with flow control as hardware.
Please advise where i could be going wrong and how i should proceed.
As mentioned above, using a binary compiled for a different board will in most cases not work.
Best regards, Stefan
===================================================================== DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: +49-8142-66989-0 Fax: +49-8142-66989-80 Email: office@denx.de =====================================================================
This SF.net email is sponsored by DB2 Express Download DB2 Express C - the FREE version of DB2 express and take control of your XML. No limits. Just data. Click to get it now. http://sourceforge.net/powerbar/db2/ _______________________________________________ U-Boot-Users mailing list U-Boot-Users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/u-boot-users