Re: [U-Boot] [PATCH v2] DaVinci: EMAC: Get EMAC_MDIO_PHY_NUM from config files

Currently EMAC_MDIO_PHY_NUM is defined as 1 in emac_defs.h. Because of this, EMAC does not work on EVMs which do not have phy connected at 1. Moving the macro to board config file makes this configurable depending on where the phy is connected on the MDIO bus.

This patch fixes the board reset issue observed during network access on DM365EVM. EMAC driver was assuming EMAC_MDIO_PHY_NUM as 1 but it is 0 on DM365EVM.

This patch is verified on da830/omap-l137, dm365 and dm644x evms.

Signed-off-by: Prakash PM prakash.pm@ti.com

Since v1: Added CONFIG_EMAC_MDIO_PHY_NUM for Davinci SONATA board config file, without which MAKEALL fails for Davinci SONATA evm.

Applied to u-boot-ti/next