On 3/24/22 10:57, Robert Marko wrote:
Update the current uDPU defconfig with following changes:
- Disable CONFIG_SPI_BOOT, its not needed for booting and the device boots
from eMMC anyway.
- Disable CONFIG_SYS_CONSOLE_INFO_QUIET, there is no need to diverge from
other boards by not priting the console device
- Enable CONFIG_CMD_MTD in order to allow use of the MTD tool
- Disable CONFIG_CMD_MTDPARTS, with MTD now being able to parse partitions
from DTS there is no need for it, the default MTDPARTS were incorrect anyway
- Enable CONFIG_MMC_HS200_SUPPORT, the eMMC used support both HS200 and
HS400 modes, so enable at least HS200 because Xenon driver does not support HS400 currently
- Replace CONFIG_SPI_FLASH_BAR with CONFIG_SPI_FLASH_SFDP_SUPPORT
Utilize SFDP parsing instead of relying on the extended address registers
Signed-off-by: Robert Marko robert.marko@sartura.hr
Applied to u-boot-marvell/master
Thanks, Stefan
configs/uDPU_defconfig | 10 ++++------ 1 file changed, 4 insertions(+), 6 deletions(-)
diff --git a/configs/uDPU_defconfig b/configs/uDPU_defconfig index b5f2115e63..1a2182b823 100644 --- a/configs/uDPU_defconfig +++ b/configs/uDPU_defconfig @@ -16,9 +16,8 @@ CONFIG_DISTRO_DEFAULTS=y # CONFIG_SYS_MALLOC_CLEAR_ON_INIT is not set CONFIG_SYS_LOAD_ADDR=0x6000000 CONFIG_FIT=y -CONFIG_SPI_BOOT=y +CONFIG_FIT_VERBOSE=y CONFIG_USE_PREBOOT=y -CONFIG_SYS_CONSOLE_INFO_QUIET=y # CONFIG_DISPLAY_CPUINFO is not set # CONFIG_DISPLAY_BOARDINFO is not set CONFIG_DISPLAY_BOARDINFO_LATE=y @@ -32,6 +31,7 @@ CONFIG_SYS_PROMPT="uDPU>> " CONFIG_CMD_GPIO=y CONFIG_CMD_I2C=y CONFIG_CMD_MMC=y +CONFIG_CMD_MTD=y CONFIG_CMD_PCI=y CONFIG_CMD_SPI=y CONFIG_CMD_USB=y @@ -41,9 +41,6 @@ CONFIG_CMD_CACHE=y CONFIG_CMD_TIME=y CONFIG_CMD_MVEBU_BUBT=y CONFIG_CMD_EXT4_WRITE=y -CONFIG_CMD_MTDPARTS=y -CONFIG_MTDIDS_DEFAULT="nor0=spi0" -CONFIG_MTDPARTS_DEFAULT="mtdparts=spi0:4m(uboot),-(rootfs)" CONFIG_MAC_PARTITION=y CONFIG_ENV_OVERWRITE=y CONFIG_ENV_IS_IN_SPI_FLASH=y @@ -56,12 +53,13 @@ CONFIG_DM_I2C=y CONFIG_DM_I2C_GPIO=y CONFIG_SYS_I2C_MV=y CONFIG_MISC=y +CONFIG_MMC_HS200_SUPPORT=y CONFIG_MMC_SDHCI=y CONFIG_MMC_SDHCI_SDMA=y CONFIG_MMC_SDHCI_XENON=y CONFIG_MTD=y CONFIG_DM_MTD=y -CONFIG_SPI_FLASH_BAR=y +CONFIG_SPI_FLASH_SFDP_SUPPORT=y CONFIG_SPI_FLASH_MACRONIX=y CONFIG_SPI_FLASH_SPANSION=y CONFIG_SPI_FLASH_STMICRO=y
Viele Grüße, Stefan Roese